AVA

Yes you are probably right.. I was going to try one layer and see how it holds up. I will try a more suitable adhesive when this one inevitably fails!

Hi! Yes 100%, I would love to try it for sure and see what effect it has. There are quite a few folks that build drums and guitars purely from fibrous materials. What I did do was order some 2" fiberglass roll for fun, it was like 15bucks so way cheaper than carbon fiber or kevlar. I will basically saturate the fiberglass in wood glue and clamp it between the wood pieces. I'll be back with the results!

I build stave drums. And currently I have one particular model called the SUPER-STAVE model that has a 3 ply stave. The two outer pieces are vertical with a piece of horizontal grained wood running perpendicular. The middle piece is quite time consuming to make as the grain has to run the short way. So considering a strip of 2" mat of some discription glued right in there to make it super strong. I make the stave pieces at around 32" long then they get machined and cut to length. My website is www.avadrums.com you'll see some stuff on the about page if your looking to kill a few mins. I'm all about doing something different so any tips are much appreciated.

Hi all. I build stave drums. And currently I have one particular model called the SUPER-STAVE model that has a 3 ply stave. The two outer pieces are vertical with a piece of horizontal grained wood running perpendicular. The middle piece is quite time consuming to make as the grain has to run the short way. So considering a strip of 2" mat of some discription glued right in there to make it super strong. I make the stave pieces at around 32" long then they get machined and cut to a shorter length after. My website is www.avadrums.com you'll see some stuff on the about page if your looking to kill a few mins! I'm all about doing something different so any tips much welcome!

Hi, is it possible to make a wood / carbon fiber hybrid ply wood? Lets say I have two pieces of wood at 50mm wide strips at 5mm thick and I want to glue them together with a layer of carbon fiber sandwiched between.. Can this be done? What sort of glue would I be using?? I'm guessing a regular PVA would be no good?! Thanks