JohnC

Well I can say that failure is expected but not the preferred mode of operation. I would assume the internal air pressure not to exceed 200psi of air as I am trying to get away from the 400 psi pressures of the air bags. That would put each 8" tube at approximately 9000 lbs assuming a 1-1.75 shaft diameter. ideally safety parameters don't need to be 3x but thats what I strive for. Each "section" would have an aluminum or composite end plates (or combination) secured on 4 sides. Its likely I don't have the weight to do it but the present bags are approx. 11lbs with the end plates being another 7-11lbs each. So right now my system is approx. 25 lbs. Side loading shouldn't be an issue as a linear guide is employed to keep the shaft perpendicular to the base. (sorry I have to be vague as I am away from my bot right now and just using cad estimates). Custom (not of the shelf) would work as well its just a last minute change out prior to my May competition. Thanks JC

Team Lone Star / Bounty Hunters / Boom Bots is trying to upgrade a bot that uses Slam Specialties Airbags. Are there any composite tubes off the shelf other than from Australia that can be used as replacement for aluminum Pneumatic tubes? Our design is a power multiplying 3 stage design 8" in diameter with a 3.5" extended length. The tube would have to be extremely smooth on the inside and structurally strong in the vertical plane. We can handle machining the end caps but if there are any suggestions for pistons and tubes (off the shelf) I would be very interested. The attached is an example but our design would most likely have input and outputs per cylinder not just a vent. Thanks JC