Jump to content

Voids where resin meets


TCook

Recommended Posts

I’ve got voids down the centre of my part where the resin fronts meet and I assume goes too fast. It’s a 2 layer 210g/sqm carbon fibre under peel ply. I have spiral tube around the whole part in a U shape which is the yellow on the picture (it’s off the part but they’re the sides it’s on). The red is where I’m pulling vacuum from and the blue is the direction of flow. How can I control the infusion to have the resin fronts meeting and going slower? Even with the resin inlets nearly fully shut off it still went fast once they met. 

IMG_9549.jpeg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...